steute RF Rx SW868 24VAC/DC Montage- Und Anschlussanleitung Seite 5

RF Rx SW868/SW915/SW917/SW922-4W 24VAC/DC
Montage- und Anschlussanleitung / Funk-Empfänger
Mounting and wiring instructions / Wireless receiver
English
Use of the mounting and wiring instructions
All actions described in these instructions may only be performed by
qualified persons who have been trained and authorised by the
operating company.
1. Read and understand these mounting and wiring instructions.
2. Comply with the valid occupational safety and accident prevention
regulations.
3. Install and operate the device.
Selection and installation of devices and their integration in control
systems demand qualified knowledge of all the relevant laws, as well
as the normative requirements of the machine manufacturer. In case
of doubt, the German language version of these instructions shall
prevail.
Scope of delivery
Device, mounting and wiring instructions, packaging.
Intended use
The four channel radio receiver is used to switch electrical loads via
radio transmission. The transmitters must support the steute
Wireless protocol.
Antenna
Use suitable antennas only:
Device type Antenna
SW868 RF antanna 860-870 MHz
SMA 1.5 m
SW915/ RF antanna 902-928 MHz
SW917/ R-SMA 1.5 m
SW922
SW868 RF magnet antanna 2dBi
SMA plug-in connector straight
2.5 m
SW915/ RF magnet antanna 2dBi
SW917/ R-SMA plug-in connector straight
SW922 2.5 m
Mount the antenna on a metal plate. The metal plate serves as an
HF counterweight. Minimum size of metal plate: 250 x 250 mm.
Note minimum sideways distance to nearest wall or disturbance
source: >300 mm. Do not bend or clamp the cable.
Minimum bending range of cable: >25 mm.
Assignment of locations and radio frequencies:
Device type Radio frequency
SW868 868.3 MHz
SW915 915.0 MHz
Mat. No.
1263761
1212092
1470770
1470773
Location According to
EU 2014/53/EU (RED)
USA FCC
Canada IC
Mexico IFT
Device type Radio frequency
SW917 917.0 MHz
SW922 916.5 MHz
Design of wireless range
The radio signal is attenuated on the way from the transmitter to the
receiver. In addition, the radio signal is influenced by obstacles. The
degree of attenuation depends on the material of the obstacle. The fol-
lowing tables serve as a guide.
Penetration of radio signals:
Material
wood, gypsum, glas uncoated
brick stone, press boards
armoured concrete
metal, aluminium lamination, water
Typical ranges:
Place of use
in free field (SW868/915/917 LR)
in free field (SW868/915/917 ULR)
in free field (SW922 LR)
in free field (SW922 ULR)
indoors (SW868/915/917 LR)
indoors (SW868/915/917 ULR)
indoors (SW922 LR)
indoors (SW922 ULR)
To get the maximum range: use the specified antennas. With other an-
tennas, the maximum range may differ.
Safety
Do not use the device in connection with other devices whose direct or
indirect purpose is to ensure life or health, or whose operation may
pose a threat to humans, animals or material assets.
N.B.
Subject to technical modifications. Reconstruction and alterations to
the device are not allowed. It is the responsibility of the manufacturer
of a plant or machine to guarantee the correct general function.
Variants
Mat. No. Variant
1244986 RF Rx SW868 4W 12 VDC Status monitoring
1319798 RF Rx SW868 4W Battery/Status monitoring
5 / 16
Location According to
Brazil ANATEL
Japan ARIB STD-T108
Penetration
90...100 %
65...95 %
10...90 %
0...10 %
Wireless range
(approx.)
450 m
700 m
150 m
230 m
40 m
50 m
20 m
25 m