Maintenance And Cleaning; Daily Cleaning Of Filters; Routine Inspection Of The Spray Arms (Once A Week); Lengthy Periods Out Of Use - AFG GSM610 Bedienungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

AfG

MAINTENANCE AND CLEANING

Although no particular scheduled maintenance is required, users are advised to have the dishwasher checked by a

specialist technician twice a year.

N.B.: the manufacturer accepts no liability for wilful damage or damage deriving from carelessness, neglect, failure to

comply with instructions, regulations and standards or incorrect connections, which lead to forfeiture of warranty cover. If

possible, leave the door ajar when not in use; Clean surfaces thoroughly and often with a damp cloth; use neutral, non-

abrasive detergents which do not use chlorine compounds, which corrode and damage stainless steel. Do not use the

products mentioned above even when cleaning the floor underneath or in the vicinity of the dishwasher, as vapours or

drops may damage the steel surfaces.

The dishwasher has IPX5 protection but pointing water jets straight at it for cleaning is forbidden

Cleaning the filter at the end of each working day

Remove the filters (simply lift them out as shown here), taking care that no large residues fall into the

sump underneath. Clean them to remove residues and rinse with plenty of water, then put them

correctly back in place; do not use sharp or pointed tools.

Clean away any limescale deposits to prevent excessive build-ups;

Remove the washing and rinsing (top and bottom) spray arms by unscrewing the central ring-nut 1; remove the parts of the

rinsing spray arms 3 by taking out the screws 2 with a screwdriver as shown below. Do not unscrew the nozzles. Clean the holes

and nozzles under a jet of clean running water; do not use tools which might cause damage. Reassemble the spray arms with

care.

Clean the outside of the appliance with a damp cloth and neutral soap, rinsing and drying thoroughly.

If the dishwasher is to be out of use for a fairly long period of time, the detergent and rinse aid dispenser devices must be

emptied to prevent crystallisation and damage to the pumps: Remove the intake hoses from the detergent and rinse aid

containers and place them in a container of clean water, then perform a few wash cycles followed by a complete pump-out.

Finally, turn off the master switch, close the water intake valve and leave the door ajar until the interior is completely dry.

The detergent and rinse aid intake hoses must be put back into the containers when the dishwasher is returned to service,

taking care not to swap them over (red hose = detergent, blue hose = rinse aid).

GSM610

Inhaltsverzeichnis

Inhaltsverzeichnis