Maintenance And Cleaning; Configuration - Steute Rf Rxt Sw868-Net Poe Originalbetriebsanleitung

RF RxT SW868/915/917/922-NET PoE
Montage- und Anschlussanleitung / sWave.NET Access Point
Mounting and wiring instructions / sWave.NET Access Point
English
Network connection status
The network socket shows the current connection status with its
two integrated LEDs:
green LED on Network link active/
green LED off Network link inactive
yellow LED blinks Send/receive data
Web interface
The Access Point has an integrated web page for configuring the
network settings and a log window to display active
wireless switches.
To access the Web page, make sure that the configuration PC and
the Access Point are in the same subnet.
For initial operation, use a point-to-point connection with both par-
ticipants in the same IP address range of 192.168.3.xxx.
Caution! Access Point and PC must not have the same IP address!
To retrieve the Web page, type in the Access Point's IP address (de-
fault: http://192.168.3.64/) in the browser.
The Web interface is secured to prevent unauthorised use (default
login: steute/steute).
The password can be changed. To restore the default password: use
the reset button to reset the device to delivery state (see above).

Configuration

Detailed instructions and further information on setting up and
configuring the access point can be found online in the online doc-
umentation linked to at the beginning of these mounting and wiring
instructions.
Troubleshooting
Error Cause
Mode LED is off No power supply or
internal power supply
unit defective
Radio LED is off No network cable,
defective network ca-
ble; network remote
station inactive
Configuration No network connec-
Web page can- tion established or
not be displayed Access Point IP and
PC IP not in the same
subnet
Access Point Switch out of range;
receives no antenna not properly
wireless tele- mounted; wireless
grams receiver defective
No server Server's IP address
connection is configuration faulty
established

Maintenance and cleaning

.steute recommends routine maintenance as follows:
1. Remove all dirt particles: Clean enclosure on the outside only.
Clean device in accordance with IP protection class. Clean with a soft
cloth and water or a mild detergent. Do not clean using
compressed air.
2. Test the function.
Disposal
- Observe national, local and legal regulations concerning disposal.
- Recycle each material separately.
Safety
Do not use the device in connection with other devices whose direct or
indirect purpose is to ensure life or health, or whose operation may
pose a threat to humans, animals or material assets.
N.B.
Subject to technical modifications. Reconstruction and alterations to
the device are not allowed. The described products were developed in
order to assume safety functions as part of an entire plant or machine.
It is the responsibility of the manufacturer of a plant or machine to
guarantee the correct general function.
Solution
Check power supply,
replace device
Change network cable;
turn on/check network
router or switch
Check network connec-
tion or adjust PC IP and
reset Access Point to
default settings
Check distance to
switch; check antenna;
replace device
Check server port and
address
5 / 12