BWT ES600 Bedienungsanleitung Seite 6

Troubleshooting Guide
Important Safety Warnings
Do not stay in the pool while the robotic cleaner is
ƒ
in operation.
Remove all objects from the pool before starting
ƒ
the cleaner.
Do not leave the cleaner in the pool when not in
ƒ
use.
Always connect the power supply through a
ƒ
Ground Fault Current Interrupter (GFCI) (USA) or
Residual Current Device (RCD) (Europe) with a
maximum rating of 30 mA.
Ensure the power connection complies with local
ƒ
and national wiring regulations.
Replace parts only with original components from a
ƒ
BWT-authorized service center.
Keep out of reach of children.
ƒ
Do not operate the cleaner if liquid flocculants or
ƒ
clarifiers have been added to the pool, as these
substances can clog and damage the filters.
Common Issues & Solutions
EN
Cleaner Does Not Turn On
Possible causes and solutions:
No power in the wall socket
ƒ
1. Disconnect the cleaner from the power supply unit.
2. Unplug the power supply from the wall, wait 30
seconds, and reconnect.
3. Turn the power on. If the cleaner does not start, try
a different socket.
Obstacle in the drive system
ƒ
1. Inspect the drive belts for obstructions or debris.
2. Remove any objects blocking the drive system.
Propeller is damaged or clogged with hair
ƒ
1. Unscrew the outlet locker located on the top
6
ES1500 ROBOTIC POOL CLEANER
outlet.
2. Check if the propeller is broken or obstructed and
clean if necessary.
Cleaner Moves but Does Not Pump Water
Possible causes and solutions:
Dirty filters
ƒ
1. Remove and clean the filters thoroughly.
Blocked or damaged propeller
ƒ
1. Unscrew the outlet locker on the top outlet.
2. Inspect the propeller for damage or debris and
clean if necessary.
Cleaner Pumps Water but Does Not Move
Possible causes and solutions:
Obstacle in the drive system
ƒ
1. Inspect the drive belts for tangled debris.
2. Remove any obstructions.
Cleaner Starts but Shuts Off After a Short Time
Possible causes and solutions:
Dirty filters
ƒ
1. Remove and clean the filters.
2. Restart the robotic cleaner.
Blocked or damaged propeller
ƒ
1. Unscrew the outlet locker on the top outlet.
2. Inspect the propeller for debris or damage and
clean if necessary.
Obstacle in the drive system
ƒ
1. Check the drive belts for any obstructions.
2. Remove debris if found.
Cleaner Does Not Pick Up Dirt
Possible causes and solutions:
Clogged or damaged filters
ƒ