BWT ES600 Bedienungsanleitung Seite 4

Cleaning Cycle
During the cleaning cycle, the robotic cleaner
systematically moves across the pool floor, collecting
dirt and debris. It automatically changes direction and
rotates according to the selected program. Every few
minutes, it climbs the pool walls as programmed in its
internal system.
Note: The robotic cleaner may pause briefly during
operation. This is a normal part of its cycle and does
not indicate a malfunction.
Stopping the Robotic Cleaner
After completing a cleaning cycle, the robotic cleaner
automatically enters standby mode, and the On/Off
button will start flashing. To manually stop the cleaner
during a cycle:
1. Press the On/Off button once.
2. The button will start flashing, indicating that the
cleaner is now in standby mode.
Removing the Cleaner from the Pool
1. Unplug the floating cable from the power supply.
2. Gently pull the floating cable until the unit is within
EN
reach.
3. Use the handle to lift the cleaner out of the pool.
Caution: Never lift the cleaner by the floating cable,
as this may cause damage.
4
ES1500 ROBOTIC POOL CLEANER
Control box & Controls
The Control box unit connects to the robotic cleaner
via the floating cable and provides low-voltage power
and commands through its output socket. It operates
using AC power and features a control panel with the
following indicators:
On/Off button - Powers the unit on or off.
ƒ
Full filter indicator - Alerts when the filter needs
ƒ
cleaning (available on some models).
Bluetooth indicator - Shows connectivity status for
ƒ
applicable models.
By following these instructions, you ensure optimal
performance and longevity of your robotic pool
cleaner.
Power Supply
On/Off
Full filter
indicator
Bluetooth
On/Off