Cleaning The Oven Door; Replacing The Light Bulb - Whirlpool FH 62 /HA S Bedienungsanleitung

Cleaning the oven door

Clean the glass part of the oven door using a sponge and
a non-abrasive cleaning product, then dry thoroughly with a
soft cloth. Do not use rough abrasive material or sharp metal
scrapers as these could scratch the surface and cause the
glass to crack. For more thorough cleaning purposes, the
oven door may be removed:
1. Open the oven door fully (see diagram);
2. Use a screwdriver to lift up and turn the small levers F
located on the two hinges (see diagram).
3. Grip the door on the two outer
sides and close it approximately
half way. Pull the door towards
you lifting it out of its seat (see
diagram).
To replace the door, reverse this
sequence.
Inspecting the seals
Check the door seals around the oven regularly. If the seals
are damaged, please contact your nearest Service Centre
(see Assistance). We recommend that the oven is not used
until the seals have been replaced.

Replacing the light bulb

! Do not use the oven lamp as/for ambient lighting.
F
To replace the oven light
bulb:
1. Remove the glass cover
of the lamp-holder.
2. Remove the light bulb and
replace it with a similar one:
Wattage 25 W, cap E 14.
3. Replace the glass cover
(see diagram).
GB
27