Replacing The Lamp; Closing The Door; Technical Data - JUNO JCZ 94181 Benutzerinformation

Problem
The temperature in the
refrigerator is too high.
The temperature in the
freezer is too high.
There is too much frost.

REPLACING THE LAMP

1. Disconnect the mains plug from the
mains socket.
2. Press on the rear hook and at the same
time slide the lamp cover in the direc-
tion of the arrow.
3. Replace the lamp with one of the same
power and specifically designed for
household appliances. (the maximum
power is shown on the light lamp cover)
4. Install the lamp cover by sliding it into
its original position.
5. Connect the mains plug to the mains
socket.
6. Open the door. Make sure that the
lamp comes on.

TECHNICAL DATA

Dimension of the recess
Rising Time
Voltage
Frequency
Possible cause
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Products are too near to each
other.
Food is not wrapped correctly.
The door is not closed correctly.
Height
Width
Depth
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Store products so that there is
cold air circulation.
Wrap the food correctly.
Refer to "Closing the door".

CLOSING THE DOOR

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
1780 mm
560 mm
550 mm
24 h
230-240 V
50 Hz
electrolux 13
Solution