Attachments On Request; Battery (Fig. 25); Battery Charger (Fig. 26); Bars And Chains - Stiga Sps 100 Li 20 S Gebrauchsanweisung

8. Excessive noise and/or
vibration is experienced
whilst working
9. The machine gives off
smoke whilst working
10. Battery power
reserve is low
11. The battery charger is not
recharging the battery
If problems persist after having performed the above operations, contact your dealer.

15. ATTACHMENTS ON REQUEST

15.1 BATTERY (Fig. 25)

Different capacity batteries are available to suit
specific operating requirements.
The list of approved batteries for this machine is
found in the "Technical Data" table.

15.2 BATTERY CHARGER (Fig. 26)

There are several devices for recharging the
battery.
Loose or damaged parts
Machine damaged
Severe working conditions
requiring greater
current absorption
Battery is insufficient for
operating requirements
Decrease in battery capacity
Batteries not correctly inserted
in the battery charger or plug
not properly connected to the
machine
Unsuitable environmental
conditions
Dirty contacts
The battery charger
is not energised
Faulty battery charger
If the problem persists, refer to the battery/battery charger manual
The list of homologated battery chargers for this
machine can be found in the "Technical Data"
table

15.3 BARS AND CHAINS

The "Correct bar and chain combination table"
contains a list of all possible combinations
between bar and chain. The same table also
provides the specification data for all chains and
bars approved for use on each machine.
EN - 15
Turn off the machine,
remove the batteries and:
– inspect for damage;
– check for and tighten
any loose parts;
– have any damaged parts
replaced or repaired with
parts having equivalent
specifications.
Do not use the machine.
Immediately turn off
the machine, remove
the batteries and
Contact an Authorised
Service Centre.
Optimise operations
Use other batteries
Purchase a new battery
Check they are
correctly inserted
Recharge the battery in places
with suitable temperatures
(see battery/battery charger
instruction manual)
Clean the contacts
Check it is plugged in and the
power socket is energised
Replace with an
original spare part