Start-Up; Working; Stop; After Use - Stiga Sps 100 Li 20 S Gebrauchsanweisung

Press the interlock
lever (Fig. 10.B) and
throttle trigger lever
(Fig. 10. A)
Release the throttle
trigger lever (Fig. 10. A)
or press the interlock
lever (Fig. 10. B).
If any of the results fail to match the
instructions provided in the tables, do not
use the machine! Contact a service centre to
have it checked and repaired if necessary.

6.3 START-UP

1. Remove the bar cover guard (Fig. 1.G).
2. Make sure the bar and the chain are not
touching the ground or any other object.
3. Fit the batteries inside their housing (Fig. 10.
H) pressing down until you hear the "clicks"
firmly into position and assure the electrical
contact;
4. Press the throttle interlock lever (Fig. 10.B)
and throttle trigger lever. (Fig. 10.A).

6.4 WORKING

Before delimbing for the first time, make sure:
– to have been specifically trained to use this
type of equipment;
– to have carefully read the safety regulations
and user instructions contained in this
manual;
– you practise first on logs on the ground or
attached to trestles, in order to get familiar
with the machine and the most suitable
cutting techniques.
IMPORTANT the machine must always be firmly
held in both hands, one hand on the front grip
area (Fig. 1. A)and the other hand on the rear
hand grip (Fig. 1. B).
Stop the machine immediately if the
chain stops during sawing.
NOTE During use, the battery is protected
against total drainage with a protective device
that switches off the machine and stops it from
working.
The levers must
move freely and
not be forced. The
chain moves.
The levers,
automatically and
rapidly, must return
to the idle position.
The chain should stop.
6.4.1 LED operation (Fig. 1. N)
LED
OFF
STEADY LIGHT
BLINKING LIGHT
6.4.2 Checks to be conducted whilst
working
• Checking the chain tension
The chain tends to stretch gradually as you work,
so you need to check its tension frequently (par.
6.1).
• Checking the oil delivery
IMPORTANT Never use the machine without
lubrication!
Make sure the bar and the chain are in
place when you check the oil delivery.
Start the motor (par. 6.3) and check if the chain oil
is delivered as shown in (fig. 11).

6.5 STOP

To stop the machine, release the throttle trigger
lever (Fig. 9.A).
After releasing the throttle control it
takes a few seconds for the toothed chain to
stop.
NOTE Always stop the machine when moving
between work areas.
Do not keep your finger on the interlock
lever when moving the machine to avoid
accidentally enabling the machine.

6.6 AFTER USE

1. Press the lock push-button placed in the
battery on the machine (Fig. 19 A), remove
the battery from its housing and recharge it
(par. 7.6.2);
2. Mount the protection bar cover (Fig. 1.G);
3. allow the motor to cool before storing in an
enclosed space;
EN - 9
ACTION
correct work
overload: the chain
is too tight or the
lubrication system is
not working
overload: machine
shutdown limit for
protection. Decrease
the cutting pressure.