Mooer WooaVerb Bedienungsanleitung

MCJCJGR
WooaVe•b
Acoustic Guitar
Owner's
Precautions
PLEASE READ CAREFULLY
Power Supply
Please connect the designated AC adapter to an AC outlet Of the correct
Please be sure to use only an AC adapter
minus. The maximum working voltage shall not exceed
dangerous equipment damage, fire or other problems
Unplug the AC power adapter when not using or during electrical
Connections
Always turn off the power of this and all other equipment
disconnecting, this will help prevent
Also make sure to disconnect all connection
moving this unit
Cleaning
Clean only with a soft, dry cloth If necessary,
Do not use abrasive cleanser, cleaning
cleaning fluids, or chemical-impregnated
Interference with other electrical
Radios and televisions placed nearby may experience
Operate this unit at a suitable distance
Location
To avoid deformation, discoloration,
this unit to the following conditions:
• Direct sunlight
• Magnetic fields
• Excessive dusty or dirty ocation
• Strong vibrations or shocks
FCC certification
This device complies with Part 15 of the FCC Rules. Operation
to the following two conditions:
• This device may not cause harmful
• This device must accept any interference
that may cause undesired operation
Main
• A digital reverb pedal specifically
• Provide players with three types of reverb
• Reverb: Simulates a Plate reverberation
• Mod: Add modulation effect to the
Reverb Pedal
Manual
BEFORE PROCEEDING
which supplies 9V (±10%) DC, center
12V, otherwise may be
storms.
before connecting
malfunction and / or damage to other devices
cables and the power cord before
slightly moisten the cloth
alcohol, paint thinners, wax, solvents,
wiping cloths
devices
reception interference
from radios and televisions
Or other serious damage, do not expose
• Heat sources
• Extreme temperature or humidity
• High humidity or moisture
is subject
interference
received, including interference
Features
designed for acoustic guitar
effects: Reverb, Mod, Filter
reverb
• Filter: Add a sweeping filter sound to the reverb
• True bypass
• DC 9V adapter
voltage
or
7. MIX Knob: Control the ratio of the guitar dry sound and the effect sound
Rotate the knob clockwise (right) will produce more effect sound presented
while rotate the knob counterclockwise
dry sound.
8. TONE/RATE/RANGE
different modes. Under Reverb/Mod/FiIter
Rate/Range
9. DECAY Knob: This knob controls the decay level of the reverb effects
Input: 1/4" monaural jack (impedance: 470k Ohms)
Output: 1/4" monaural
Power Requirements:
recommended
Current Draw:
Dimensions:
players
Weight: 145g
Accessories:
switch
power supply
Panel Instruction
1. TRUE BYPASS
Push down the footswitch to toggle
between on and bypass status.
2. ONIOFF
Shows the
WoodVerb,
lit the effect is engaged
3. DC IN Power
For power supply, use a 9-volt DC
regulated AC adapter (plug polarity
is positive on the barrel and negative
DEC ÄY
in the center)
4. INPUT Jack:
1/4" mono audio jack, for connecting
guitar.
5. OUTPUT
114"mono audio jack, outputs the signal
0
6. Mode Switch:
Change
Reverb/Mod/Filter.
(left) will have more of your guitar
Knob: This knob controls different parameters
mode, this knob controls Tone/
respectively.
Specification
jack (impedance: 100 Ohms)
AC adapter 9V DC (center
to use Mooer Micro Power
130 mA
93 5mm (D) x 42mm (W) x 52mm (H)
Owner's Manual
Footswitch:
LED:
onloff status of
when the LED is
Jack:
Jack:
the reverb effect types from
under
minus plug),
Part No:2030501679