cozze CG-PZ03A-3-BK Gebrauchsanweisung Seite 10

INSTRUCTIONS FOR USE
Follow these instructions carefully to avoid seriously damaging your pizza oven and causing
injury to yourself and to property.
1. Assemble the pizza oven by following the assembly instructions carefully.
2. Connect the gas hose to the pizza oven. Connect the regulator to the hose.
3. Connect the regulator to the cylinder valve following the regulator instructions supplied
with the regulator.
4. Turn all of the control knobs to the 'OFF' position before turning on the gas supply to the
appliance.
5. Operate the regulator in accordance with the instructions supplied with the regulator.
LIGHTING YOUR PIZZA OVEN
1. Connect the gas cylinder to the pizza oven following the instructions supplied with the
regulator.
2. Turn the control knob to the 'OFF' position.
3. Turn 'ON' the gas supply at the cylinder or regulator switch following the regulator
connection and operating instructions. Check the cylinder to regulator connection and
hose to pizza oven hose inlet connection for leakage using soapy water. Any leakage
will show as bubbles in the area of the leak. If leak is found, do not use the pizza oven.
Consult your gas or pizza oven supplier for advice.
4. To light the burner, push down the control knob and keep pressing whilst turning anti-
clockwise to the "Full rate" position and press the ignition button. This will light the
burner. Check that the burner is alight. If the burner has not lit, repeat this process.
5. If the burner has not lit after two attempts, turn 'OFF' the gas tap and wait 5 minutes
before retrying the ignition sequence.
6. When the burner has lit, the burner rate can be adjusted by push down and turn the
knob anti-clockwise to any position between the full and low rate position.
7. After the oven is heated for use, the temperature should be turned down during baking.
The oven emits a lot of heat, and the temperature must therefore be adjusted to the
correct baking temperature.
8. To turn 'OFF' the pizza oven, turn the cylinder valve handle or regulator switch to
the 'OFF' position by following the regulator instructions. Once the burners have
extinguished turn all the control knobs to the 'OFF' position.
10