cecotec CECORAPTOR PERFECT FIX Bedienungsanleitung Seite 264

ENGLISH
2. Unplug the charging plug (7) from the power socket (socket
base).
3. Unplug the glue gun from the charger.
4. The device and the charger can heat up during charge.
Testing the battery charging status
The battery status is shown in the battery indicator.
- Green LED light: fully charged.
- Red LED light: empty battery. Charge the battery.
Placing the glue stick
You must introduce the glue stick into the stick input (9).
Using the glue gun
- First, you must degrease the metal surface before gluing.
Remove any remains like oil, synthetic lubricant, etc.
- Moist can cause glued surfaces to separate.
- If glue comes into contact with skin, apply cold water for some
minutes on the affected area.
264
RAPTOR PERFECT FIX 360 X-TREME
- If you need to glue a highly heat-sensitive material, try it first
with a test piece.
- In textile products it is not possible to remove the glue
completely. It is also not possible to remove it by washing at
high temperature.
- If necessary, use special glues for different materials to the
ones specified in this manual.
- Do not try to glue highly flammable or combustible materials.
- Do not work on a highly flammable or combustible base.
Gluing
- To glue flexible materials, like textile products, apply glue in a
zig zag pattern.
- Quickly cooling materials should be pre-treated with a hot air
gun, so that the glue will adhere better.
- Tighten and press the pieces after gluing them with your
hands. It is not necessary to use a clamping device.