Werbung
-
You can glue in dots or in a lineal pattern.
-
To remove glue remains once it has cooled doen, you can use a
sharp blade. Use extreme caution to avoid possible cuts.
-
It is recommended to sand flat surfaces before gluing them.
-
If you want to unglue glued areas, just heat them up.
-
The glue remains can be removed once they have cooled down.
-
Glued areas can be painted.
Plugging and unplugging the device
It is highly recommended to use personal protective equipment
during the use of the glue gun. Hold down the on/off switch (2)
until the status LED (1) turns red. Fig.5
-
Glue will start to heat up.
-
When the glue gun has reached the optimum work
temperature, the status LED will turn green.
-
Now the device is ready for use.
1.
To turn it off, you must hold down the on/off switch (2) until
the status LED (1) is off. Fig.6
Auto off
-
The auto off starts after approximately 10 minutes of
inactivity.
-
It is recommended not to turn on the device until it is used.
-
Turn the device on again by holding down the on/off switch (2)
and check the status LED as well as the charging indicator, in
case you will need to charge or heat up the device again.
Gluing
Note
Warning due to hot surface
The nozzle can be hot after its use. The
glue that comes out of the nozzle can
also be hot. You may get burnt.
-
Do not ever touch the nozzle directly with your hand!
-
Use protective gloves!
RAPTOR PERFECT FIX 360 X-TREME
ENGLISH
265
Werbung
