Functional Interfaces - Atomstack Hurricane Bedienungsanleitung

03

Functional Interfaces

1
4
5
6
1
Reset/Pause
2 Auto focus
Water inlet
3
4 E-stop
5 Switch key
6 Power on/off & Power outlet
3
2
1.1 During the engraving process, you can press the button to pause the work. Close the lid and press the button again to resume the work;
1.2 When an abnormal alarm occurs, after resolving the problem, press this button to restore the machine to its normal standby state.
Click the button to automatically focus on the current material.
Cooling water is added to the tank through this port.
In case of emergency, press the button to stop operation.
Insert the key and turn it clockwise to power on.
Plug the power cord into the socket and press the main switch to turn on the machine.
7
8
05
10
9
11