Faq - Atomstack Hurricane Bedienungsanleitung

12
Q&A
1. The machine does not respond when the power switch is turned on?
1.1 Check if the emergency stop switch is pressed. If it is, rotate it to reset；
1.2 Check if the key switch is turned to the "ON" position.
2. How to clean the debris after cutting?
2.1 Pull out the drawer, remove the honeycomb board, and use a brush to clean off the debris on the honeycomb board.
3. Do I need to purchase protective glasses when using ATOMSTACK HURRICANE?
3.1 The HURRICANE's protective cover is designed to filter laser light and has a detection function when the box is opened, so there is no need to purchase protective glasses.
4. Can ATOMSTACK HURRICANE cut glass or engrave on glass?
4.1 It cannot cut glass, but it can engrave on glass.
5. Can ATOMSTACK HURRICANE cut metal or engrave on metal?
5.1 It cannot cut metal, but it can engrave on coated metal plates (including stainless steel) and anodized aluminum.
6. What is the maximum thickness of transparent acrylic that ATOMSTACK HURRICANE can cut?
6.1 It can cut transparent acrylic up to 20mm thick.
7. How to transport ATOMSTACK HURRICANE?
7.1 For short-distance transport: remove the exhaust pipe, unplug the power cord, and wrap the four corners of the machine with PE foam for transport；
7.2 For long-distance transport: remove the exhaust pipe, unplug the power cord, secure the laser module, X-axis gantry, drawer, honeycomb board, protective cover, and other movable parts,
and repackage the HURRICANE using the original packaging materials and methods as much as possible.
8. Can reflective metal materials be engraved?
8.1 It is not allowed to process on high reflectivity materials directly, as it can cause irreversible damage to the machine.
15