Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PRECAUTIONS
•
Do not install thermostat in direct sunlight
•
Do not install on severely cold outer walls
•
If the thermostat is not in the same room as the heat-
ing, the floor sensor only setting can be used
•
Install floor sensor min 0.5m from the wall (cable can
be extended with up to 7m, min. 2x0.5mm² cable)
•
Do not cover the thermostat, this will cause over-
heating
•
All connections to the thermostat must comply with
national regulations and be installed by an author-
ised electrician
•
Power supply to the thermostat must be supplied
through a 30mA RCD and overload protected
through max.16A fuses
18
INSTALLATION
Remove front panel by loosening the
screw in the bottom, pull out on the lower
half of front panel.
Assemble by inserting tabs of front panel into base panel, tilt
the lower half in and tighten the screw
19
Werbung
