Philips ADD5962 Bedienungsanleitung Seite 11

Prime the �lter
・ Soak the �lter cartridge in clean water for 15 minutes. Shake the �lter cartridge slightly to wash
the carbon powder off. (A-1)
Note:
It is normal to have carbon powders on the �lter cartridge surface. They are harmless, and they
will not appear during subsequent use.
1
Fill the tap water tank
・ Fill the water tank with ambient tap water.
Note:
DO NOT over�ll the tap water tank.
Clean and turn on the cooling tank
・ Fill the cooling tank by pressing "
and " ". Repeat this 3 times until the water
comes out from the nozzle. (B-1)
・ Remove the tap water tank from the appliance.
・Unplug the power supply.
・Locate the cooling tank drain outlet at the bottom of
the appliance. Place a container of 1L under it.
・ Remove two silicone plugs from the drain outlet.
Wait until there is no water coming out, and
re-insert the silicone plug tightly. (B-2)
・ Put the tap water tank back into the appliance.
・ Fill the cooling tank again by pressing "
"450ml", and "
water comes out from the nozzle.
2
A-1
", "450ml",
". Repeat this 3 times until the
1
3
",
11
2
B-1
B-2