Philips GC4720/02 Bedienungsanleitung Seite 12

EnGlISh
12
Problem Possible cause
You have put an additive in
the water tank.
You have used the steam
boost function at a
temperature setting below
3.
Water drips from The iron has been put in
the soleplate after horizontal position with
the iron has water still left in the water
cooled down or tank.
has been stored.
Flakes and Hard water forms flakes
impurities come inside the soleplate.
out of the
soleplate during
ironing.
The red auto-off The automatic shut-off
light flashes function has switched off
(specific types the iron (see chapter
only). 'Features').
The blue tank The automatic shut-off
light flashes function has switched off
(specific types the iron (see chapter
only). 'Features', section
'Automatic shut-off
function').
The iron makes a The Ionic DeepSteam
humming sound. function is on.
All manuals and user guides at all-guides.com
Solution
Rinse the water tank and do not put any
additive in the water tank.
Set the temperature dial to a setting between
and 3 and MAX.
Empty the water tank before you store the
iron. Store the iron on its heel.
Use the Calc-Clean function one or more
times (see chapter 'Cleaning and maintenance',
section 'Using the Calc-Clean function').
Move the iron slightly to deactivate the
automatic shut-off function. The red auto-off
light stops flashing.
Move the iron slightly to deactivate the
automatic shut-off function. The blue tank light
stops flashing.
If you hear the humming sound when you iron
without steam, stop pressing the Ionic
DeepSteam trigger. The Ionic DeepSteam
function has no effect when you iron without
steam.