PowerLocus PLED Benutzerhandbuch Seite 5

Operating frequency
Rated power consumption
Maximum output power
Operating temperature
On/Off
1. To power on the headphones, press and hold the multifunction button for two
seconds. The LED indicator will flash blue for two seconds.
2. To power off the headphones, press and hold the multifunction button for four
seconds. The LED indicator will flash red for two seconds and then goes off.
Bluetooth Pairing
Press and hold the multifunction button for five seconds until the LED indicator
•
flashes blue. A moment later, the headphones will automatically enter pairing
mode, with the LED flashing red and blue alternately.
Activate the Bluetooth function on your device. Select the PowerLocus PLED from
•
the list of Bluetooth devices found by your device and connect.
Switch Volume Limiter Modes
In order to change the volume sensitivity, click the [+] and [-] buttons at the same time
until you hear voice prompts stating the volume sensitivity.
Mode Switch Button
1. Short press the mode switch button, and you can switch multiple light modes at
will.
2. Long press the mode switch to switch between Bluetooth mode and Memory
card mode.
Operation of Buttons
Volume up
Volume down
Next track
Previous track
Play/pause
Answer/end a call
Reject a call
2400MHz~2483.5MHz
20mW
<6dBm
0-45°C
Short press the [+] button.
Short press the [-] button.
Press and hold the [+] button for two
seconds.
Press and hold the [-] button for two
seconds.
Press the multifunction button once.
Press the multifunction button once.
Press the multifunction button several
times until the ringtone stops.
5