Cleaning Method - Wanbo T6R Max Benutzerhandbuch

Cleaning Method

Please make sure to unplug the projector from the power source before maintenance.
Do not use pesticides or other volatile chemicals on the projector or lens. Do not let
rubber or vinyl products contact the projector for a long time, which will damage the
coating and make it peel off.
Cleaning the projector.
Wipe with a soft, dry cotton cloth. If it is dirtied seriously, swipe with soft cloth
•
and diluted neutral detergent, then dry with a clean, dry cloth. Please pay more
attention if used with chemical fibre cloth.
Don't use thinner, benzene, or any other solvents to avoid quality reduction or
•
coating peeling off etc.
A brush can be inserted in front of the vacuum cleaner to remove dirt inside the
•
vents. Don't use vacuum cleaner with no connector or clean the vents directly.
Don't scrape the projector with nails or any other hard objects so as to avoid
•
scratches.
Lens cleaning.
Clean lens with the same method as you would clean any camera lens. Use a
•
professional blow dryer or cleaning paper for glasses, ensuring lens are not
scratched.
Inlet and outlet dust cleaning.
Dust in the inlet and outlet will prevent ventilation and increase the internal
•
temperature, which will cause a defect.
Disconnect the projector from the power source after turning off the projector.
•
Clean the exterior with an electric vacuum cleaner with brush installed. Don't use
•
the vacuum cleaner with no adapter.
8