Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Fan: Turn the robot over and wipe any debris from the fan with a cloth to maintain suction.
Guide wheels: Turn over the robot and wipe the four side rollers with a cloth to maintain their
effectiveness.
Edge Detection Sensors: Turn over the robot and
wipe five edge detection sensors clean with a cloth
to maintain their effectiveness.
Squeegees: Turn over the robot and wipe the squee-
gee with a cloth to maintain their effectiveness.
Driving treads: Before cleaning
the wheels, move the power
switch to the "-" position. Then
wait 8 seconds until it stops suc-
tioning and starts beeping. Then
press "
" key on the remote
control and start cleaning the dri-
ving wheels.
Press Start/Pause and Clean bu-
ttons on the remote control to
check the driving wheels, if the-
re is any dust, press pause and
clean the dust.
After cleaning, turn off the
switch on of the bottom part to
the "O" position.
32
Light status indicator
Blue light flashing
Ready, you can put the product on glass.
Ready, product suction is successful, it remains attached to window
Blue light bright
and it can start cleaning the window.
Power adapter is not connected or vacuum is not enough. If the cord is
Red light flashing
unplugged and the product starts beeping, remove the product from
the window or plug it again to a power supply.
6. TROUBLESHOOTING
REF. Nº
ERROR
REASON
If the blue light flas-
Cleaning correctly
hes, the robot is
not installed
checking that con-
correctly
ditions are proper to
1
work. If this process
Free fall sensor error
takes longer than 20
seconds, it can be
due to any of these
The glass surface is
three errors.
too dirty
Red light flashing
Power adapter not
2
and beeps warning
connected
SOLUTION
Remove the cleaning mop and
install it again to make it flat.
Check if the free fall sensor has
any foreign matter that stops it
from working properly.
Clean an area first to make the
product stick on the glass.
A. Connect to the power supply
first, and press Start to make the
product work again.
B. In case of power cut, use re-
mote control to direct the product
to the place where safely reach it
and remove it.
There is some risk when using
remote control under power cut,
please make sure that highest sa-
fety precautions are taken.
33
Werbung
