Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setup example
Installation
Install the unit on a plane surface or in a rack. The rack should be provided with doors on the front and rear panel
and a cooling fan. When mounting the device into the rack, please make sure that there is enough space around
the device so that the heated air can be passed on. Steady overheating will damage your device. You can fix the
device with four screws M6 in the rack.
Suspended installation
Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure that the
device is installed securely and cannot fall down. The installation must be carried out by a specialist
who is familiar with the hazards and the relevant regulations.
1) The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
2) Block access below the work area and work from a stable platform when installing the device.
3) Use rigging hardware that is compatible with the structure and capable of bearing the weight of the device.
Please refer to the "Accessories" section for a list of suitable rigging hardware.
4) Secure the device with a safety bond or other secondary attachment. This secondary safety attachment must
be sufficiently dimensioned in accordance with the latest industrial safety regulations and constructed in a way
that no part of the installation can fall down if the main attachment fails. Use the safety eyelet for fixation of the
safety bond. Fasten the safety bond in such a way that, in the event of a fall, the maximum drop distance of
the device will not exceed 20 cm.
5) After installation, the device requires inspections periodically to prevent the possibility of rot, deformation and
looseness.
SETUP
WARNING!
23 • EN
Werbung
