Moza Racing RS Steering Wheel Benutzerhandbuch Seite 6

Installation of Paddle Approach Block
Use the hexagon wrench in the screw kit to remove the two screws on the shift paddle,
add the heightening block, and tighten it with the attached long screw. Using this gasket,
the distance between the paddle and the hand can be shortened by 8mm.
Installation of Magnetic Suction Paddle Mute Pad
Place the steering wheel on a flat surface with the surface facing down, use a hexagonal
wrench to remove the screw on one side of the shift paddle trigger rod, and then use a
wrench to push the pin from the side of the magnetic suction paddle (it is not necessary
to push the pin out completely, only to separate the magnetic suction paddle trigger rod
and the pin), and then stick the mute pad on the convex position on the back of the
paddle trigger rod, as shown in the figure. Finally, return the latch, and replace the
screw.
For more information and teaching videos, please log in to the official website.
6