Werbung
Pull upwards on the adjusting ring (07) in the direction of
2)
the arrow to the maximum
height
3)
Press on the release handle (09) in the direction
arrow to release the headrest (08), and then adjust the
headrest
(08) up or down
to the desired
release
of this hand e (09), the headrest
place
automatically.
The headrest
(08) is in the correct
4)
diagonal
belt section (I O) of the 3 point vehicle belt sits
on the child' s shoulders and when you can fit 2 fingers
between
the bottom
edge
of the headrest
shoulder
of the
child
2.4 Adjust recline
position
2.4.1 With Top Tether (Apramo@ Dual Tether@)(Group 1/11/111,
Forward Facing)
Press the release button of the Top Tether adjuster B (47)
to release the Top Tether strap (48) to the desired ength
Pull and hold the release handle (1 1) to adjust the child
2)
car seat (12) to the desired
recline
release of this handle
(1 1), the child car seat (12) will
ock into place
automatically.
3)
Ensure
the
child
car
seat
is at
position,
and then tighten
the free end of Top Tether
adjuster B (47) until the indicator shows green
2.4.2 Without Top Tether (Apramos Dual Tether@)(Group 11/111)
Pull and hold the release handle (1 1) to adjust the child
car seat (12) to the desired recline position. Upon release
of this handle
(1 1), the child car seat (12) will ock into
place
automatically.
CAUTION!
The child
restraint
system
fullest recline position (Group 0+/1, Rearward Facing).
GB
12
of the
position.
Upon
will lock into
08
position
when the
09
and the
20
08
47
48
position
Upon
the
desired
recline
21
12
must
be
always
in
13
10
2.5.2 To rotate 1800 with Top Tether (Apramo@ Dual Tether@)from Rearward Facing
(Group 0+/1, Rearward Facing) to Forward Facing (Group I, Forward Facing)
Pull the rotation button (13) outwards to release the child car seat (12), and then rotate the
child car seat (12) by 1800, at where the child car seat will ock into place automatically.
Unthread the Top Tether strap (48) out of the bet guide (17) (Refer to section 2.2.2)
2)
3)
Adjust the recline position to the desired
4)
Ensure the child car seat is at the forward facing position, and the desired recline position
11
Then tighten the free end of Top Tether adjuster B (47) until the indicator shows green
2.5.3 With Top Tether (Apramo@ Dual Tethero in Forward Facing (Group 1/11/111)
Press the release button of the Top Tether adjuster B (47) to release the Top Tether strap
(48) to the maximum or desired length
Pull the rotation button (13) outwards to release the child car seat (12), and then rotate
2)
the child car seat (12) by 900 or 1800, at where the child car seat will lock into place
automatically.
2.5 Use 3600 rotation
system
22
12
2.5.1 To rotate 900 with Top Tether (Apramo@ Dual Tethero in
Rearward Facing (Group 0+11, Rearward Facing)
Pull the rotation button (13) outwards to release the child
car seat (1 2), and then rotate the child car seat (12) by
900, at where the child
automatically
To rotate it back to the rearward facing position: pull the
2)
rotation
button
(13) outwards
seat (1 2), and then rotate the child car seat (12) by 900
back to the rearward facing position, at where the child
car seat wil ock into pace
3)
Ensure the child
car seat is at the rearward
position, and in fullest recline position
Double check the Top Tether. If necessary,
4)
free end of Top Tether adjuster B (47) until the indicator
shows green
position if necessary
car seat will lock into place
to release the child car
automatical
y.
facing
tighten the
(Refer to section 2.4. I)
GB
13
Werbung
