Removal; Of The Child Car Seat; Removal And Installation; Of The 5-Point - Apramo Unique Bedienungsanleitung

4. Removal

of the Child Car Seat
4.1 ISOFIX + Top Tether (Apramo@ Dual Tether@)
l) Press the ISOFIXrelease buttons to release the ISOFIXconnectors,
connectors back into the base of the child
2) Press the release button of the Top Tether adjuster B (47) to release the strap and unlock
the snap hook (18) from the vehicle anchorage
3) Remove the child car seat from the vehicle
4.2 3-point vehicle belt + ISOFIXconnectors + Top Tether (Apramog Dual Tether@)
Release the buckle tongue from the vehicle seat buckle. Unthread 3-point vehicle
from the child car seat and allow
Press the ISOFIXrelease buttons to release the ISOFIXconnectors,
2)
connectors back into the base of the child
3)
Press the release button of the Top Tether adjuster B (47) to release the strap and unlock
the snap hook (18) from the vehicle anchorage
4) Remove the child car seat from the vehicle
5. Removal and installation

of the 5-point

5.1 Removal of the 5-point harness
Press down on the central adjuster (04), and pull the
shoulder straps towards you (05), extending
harness as far as it will go DO NOT pull on the shoulder
pads (06).
2) Pul the adjusting ring (07) upwards, whilst pushing the
headrest (08) downwards to appropriate
Turn the child car seat around so that the rear is facing you.
3)
Unlatch the rear cover (31).
GB 22
push the ISOFIX
restraint.
point.
seat
it to retract.
push the ISOFIX
restraint
point.
seat
05
06
19
harness
08
the 5 point
position
31
32
33
32
belt
35
36
06
05
4) Remove the webbing (40) from the joint plate (32)
5) Place the joint plate (32) under the clip (33) shown in the
cover.
40
Remove the oops of the shoulder straps (34) from the
6)
headrest lever (35)
Put the rear cover back (31 )
7)
Turn the child car seat around so that the front is facing you.
39
Pull out the shoulder belts (05) and shoulder pads (06)
8)
from the headrest slots (36) in front of the headrest.
Open the buckle (19) of the 5-pdnt harness
9)
40
Unfasten the fabric cover
10)
atches into the child car
then refasten the fabric cover (37)
11) Turn the metal pate (38) to be vertical
the housing (39), remove the 5-point harness buckle (19)
42
39
(37) and place the buckle
seat back on each side, and
and remove from
GB 23