Zipper ZI-HDR200 Bedienungsanleitung Seite 23

2.5.2 Shut down
 Turn off the motor(push switch to the off po-
sition)
 Unplug the unit from the power source.
 Turn off the water supply.
 Press the trigger of the gun to depressurize
the system.
 Disconnect the garden hose from the pres-
sure washer.
 Wipe all surfaces of the unit with a damp
clean cloth.
2.5.3 ADJUSTABLE SPRAY NOZZLE
Turn off the spray lance first, hold the rear part of
spray nozzle, then turn the front part of spray noz-
zle clockwise, Water may be sprayed out from the
spray nozzle in fan shapes (pic. 1 on Fig. B); Turn
the front part of spray nozzle withershins, Water
may be sprayed out from the spray nozzle linearly
(pic 2 on Fig. B).
2.5.4 Low/High Pressure Adjustable Lance
2.5.4.1.
Please make sure the trigger released and there is not any water spraying. Then turn the rear part
of spray nozzle withershins (pic 4 on Fig. B). Squeeze the trigger, the gun will spray water with high
pressure.
2.5.4.2.
Please make sure the trigger released and there is
not any water spraying. then turn the rear part of
spray nozzle clockwise (pic 3 on Fig. B). Squeeze
the trigger, the gun will spray water with low pres-
sure.
Using High Pressure:
Using low pressure:
C A U T I O N
ALWAYS turn off the unit's motor
BEFORE turning off the unit's water
supply.
Serious damage could occur to the
motor if the unit is run without water.
C A U T I O N
NEVER disconnect the high-pressure
discharge
Hose from the machine while the sys-
tem is still pressurized. To depressur-
ize the unit, turn off the motor, turn
off the water supply and squeeze the
trigger 2-3 times.
C A U T I O N
Water should be sprayed out from the
spray nozzle in fan shapes (pic 2 on
Fig. B),when cleaning the car or oth-
er vehicle.
C A U T I O N
Selection of high or low pressure by
turning action. The selection of the
pressure must be carried out with the
gun in closed position.
23