Workings Before Starting Up - Zipper ZI-HDR200 Bedienungsanleitung

 To reduce the risk of electrocution, don't start and run the machine in the rain or storm. Keep all connections dry and
off the ground. Do not touch plug with wet hands. It is strictly prohibited to let water leak into the machine.
 When the machine is running, please maintain a constant water supply. Without water circulation will damage the
sealing rings of the machine.
 It is necessary to turn on the spray lance within one or two minutes after the machine has been started. Otherwise,
the temperature of the circulating water within the machine will soon rise to a critical point, which will cause damage
to the sealing rings inside the machine.
 Don't start and run the machine in a place excessively cold so as to prevent the machine from the freezing current.
 This machine has been designed for only using cleaning water, do not use corrosive chemicals.
 Disconnect from the electrical power supply before carrying out user maintenance.
 Make sure the inlet water pressure keeps between 0.01MPa and 0.4MPa.The inlet pipe should at least 5 M long. Do
not use the pipe if the pipe is damaged. If you want connect this machine to portable water mains, you must install a
backflow preventer in the water pipe to prevent dirty water flow back to the drinking water system. The backflow
preventer shall comply with.
2.5 Operation instructions
2.5.1

Workings before starting up

 Reading, understanding and obeying the safety instructions.
 Unpacking all the parts. Controlling the machine on dust and other dirt.
 This unit is to be connected to a cold water source ONLY
 The motor of this pressure washer will NOT run. It will only operate when the trigger is
squeezed.
 Connect the outlet hose to the washer and connect the spray gun to the outlet hose.
 Connect nozzle and nozzle extension.
 Check gauze filter is clear of any blockage.
 Connect the water supply hose.
 Check that the hose has no kinks in it.
 Turn on water and check for leaks.
 Depress trigger to allow air to be expelled though the pump and hoses, lock trigger.
 Plug in machine and turn on switch.
 Unlock trigger and use the pressure washer.
22