Zipper ZI-HDR200 Bedienungsanleitung Seite 19

2.2 SAFETY
2.2.1 Intended usage
The ZIPPER high pressure cleaners ZI-HDR200 and ZI-HDR230 are only admitted for the following
works at observance of the safety-, operation- and maintenance instructions:
 Trench tamping
 Clean cars
 Bikes
 Outdoor equipment
 Garden patios
 Green houses etc.
When you don't take care of the intended usage
and at non-compliance of the instructions in this
manual you will lose all the compensation de-
mands from the ZIPPER GmbH.
Changes and manipulations on the machine also
lead to the expire of the guarantee and compensa-
tion demands.
2.3 Helpful
Started
2.3.1 Automatic ON/OFF:
The motor on this pressure washer does not run continuously. It only runs when the trigger of the
spray gun is squeezed. After following the start up procedures in this manual, turn the pressure
washer ON and squeeze the trigger for activation. See the section of this manual entitled "Operat-
ing Instructions" for further details on this feature.
2.3.2 Bleeding the Gun:
It is very important to bleed the gun before using the pressure washer. Squeeze the trigger to allow
any air that is trapped inside of the unit and hose to escape. Continue to squeeze trigger until a
steady stream of water comes from the nozzle. (This process may take up to 2 minutes). See the
section of this manual entitled "Operating Instructions" for further details on this process.
Hints for Getting
Always be focused when working,
take care to maintain a safe posture
at every time.
The machine shall be used only by
trained persons.
Non authorized persons, especially
children, shall be kept away from the
work area.
19