Zipper ZI-HDR200 Bedienungsanleitung Seite 26

2.9 Possible problem and solution
Disconnect the machine from the power supply prior to any checks performed at
the machine itself!
FAULT
When switched on
the machine will not
start working
Fluctuating Pressure
Water leaking from
the pump.
The motor stops
suddenly.
The pump doesn't
reach the necessary
pressure.
PROBABLE CAUSE
 Plug is not well connected or
electric socket is faulty
 The main voltage is insuffi-
cient, lower than minimum re-
quirement
 The pump is stuck.
 Thermal safety switch has trip-
ped
 Pump sucking air.
 Valves dirty, worn out or stuck.
 Pump seals worn out.
 Seals worn out.
 Thermal safety switch has
tripped due to overheating.
 Water inlet filter is clogged.
 Pump sucking air from connec-
tions or hoses.
 Suction/ delivery valves are
clogged or worn out.
 Unloaded valve is stuck.
 Lance nozzle incorrect or worn
out.
REPAIR
 Check plug, socket
 Check that the main voltage is adequate.
 Switch off the unit and let the motor cool for
a few minutes
 Leave the lance open
 Check that hoses and connections are air-
tight.
 Clean and replace, or refer to dealer..
 Check and replace, or refer to dealer.
 Check that the main voltage corresponds to
specifications.
 Switch off the unit and let it cool for a few
minutes.
 Clean the water inlet filter.
 Check that all supply connections are tight
 Check that the water feeding hose is not
leaking.
 Clear or replace valves.
 Loosen and re-tighten regulation screw.
 Check and/or replace
26