Trouble Shooting - Pharo Funpool Montageanleitung

troUBle shootInG

Type of Malfunction / Cause
Air system does not function
Hydro system function insufficient
Hydro system does not function
System switches itself on without an
obvious reason
Water nozzle
Leakage:
air
Water underneath the tub
Underwater lighting does not switch on
Disinfektion:
Can not be started
Switches off during the process

English
Possible Cause
Check you have an electricity supply?
Malfunction in electrical mains
Are the plug connections to the
control correctly seated?
Control does not react
Control defective
Control element defective
Blower defective
Filter at intake socket is blocked
Nozzle dirty
Is voltage applied?
Malfunction in electrical mains
Are the plug connections to the
control correctly seated?
Is the water level high enough?
Water level sensor does not react
Control does not react
Control defective
Control element defective
Hydraulic pump defective
Automatic cleaning function of the air
nozzles
Has the room temperature changed
(e.g. floor heating underneath the
whirlpool)
Has the humidity in the room changed
(e.g. use of a shower in the same room)
Were cables, water pipes or other
electrically conductive materials laid in
the area of the water level sensor?
Is/was cleaning work performed near
the tub? (e.g. moist cleaning cloth near
the water level sensors)
Nozzle dirty
Nozzle head not adjustable
is seized
is loose
Air hose loosened on:
Blower
Air distributor
Air nozzle
Hydro hose loose on:
Pump
Hydro nozzles
Drain/overflow defective?
Seals on nozzles leaking?
Acrylic material damaged?
Tub inflow connection leaking?
Is the water level high enough?
Lighting element defective?
Is voltage applied?
Malfunction in electrical mains
Are the plug connections to the
control correctly seated?
Water level sensor does not react
Is the water level high enough?
Is the water level high enough?
Is the disinfectant container adequately
filled?
Possible Clearance
Call electrician
Pull and reinsert plug
Reconfigure Poolmaster
Replace control
Replace control element
Replace blower
Remove cover at intake socket and
clean filter (see service)
Clean nozzle (see service)
Call electrician
Pull and reinsert plug
Continue to fill tub
Adjust sensor
Replace sensor
Reconfigure Poolmaster
Replace control
Replace control element
Replace hydraulic pump
Okay
Readjust sensitivity of the water level
sensor
Readjust sensitivity of the water level
sensor
Reposition cables, water pipes or similar
Remove objects from the tub
Clean nozzle (see service)
Reposition O-ring behind head
Replace O-ring behind head
Tighten hose clamp / disconnect and
reconnect hose
Retighten hose clamp
Replace seals
Replace seals
Repair acrylic material with repair sets
Replace seals
Continue to fill tub
Replace lighting element
Call electrician
Pull and reinsert plug
Adjust sensor
Replace sensor
Continue to fill tub
Continue to fill tub
Replenish container with disinfectant.