Running-In Period; Safety Instructions - Wilson Raptor Serie Bedienungsanleitung

Choose a cable of suitable length and diameter for each loudspeaker - a loudspeaker cable is
polarised, with twin cores of different colours, or with a rib or printed text on the insulation.
Split the twin cores insulation to a depth of about 50-60mm.
leaving about 15mm of bare wire - twist wire to gather any loose strands.
Ensure that positive terminals
the positive output terminal
(marked - and coloured
Incorrect connection
Keeping the loudspeaker
WARNING: Do not plug into a power source and mains outlet, this could result in electric
shock
Running-in
We recommend
at normal listening
time the driveunits
Maintenance
WILSON loudspeakers
should be done with a damp cloth. Chemical cleaners should be avoided, as they may
damage the finish.
Avoid touching
drinks table (risk of water or liquids being spilled into the loudspeaker)
Wilson Raptor loudspeakers
Troubleshooting
If no sound, check;
• that all cables are connected
• that the connected
• that the loudspeaker

Safety Instructions

WARNING read
• Please store this
• Do not plug into a power source and mains outlet, this could result in electric shock or fire.
• Place the unit
• Do not use this product near water or moisture.
• To prevent risk of fire avoid liquids and objects enter the product.
• Do not block any ventilation
• Do not install near any heat sources, such as radiators,
appliances that produce heat
• Servicing is required when the product
• Do not attempt
• Contact the manufacturer
EN
on the speakers (marked + and coloured
on the amplifier
black) are connected to the negative output terminal
can result in poor imaging and loss of bass.
cables away from AC outlets will reduce interference.
or fire.
period
a running-in time of your new loudspeakers
level before you decide on the final positioning,
will settle in and perform
are finished using high quality
the drive units, and do not use the loudspeakers
require no regular maintenance.
properly to both loudspeaker
amplifier is ON and volume is turned up
gets a signal from the amplifier
before use
instruction manual
on a solid surface.
openings.
to service this product yourself.
to be refered to an authorized
and that negative terminals
as intended
material. Cleaning the loudspeakers
check tone on most av receivers.
for future reference.
heat registers, stoves or other
has been damaged
4
Strip the insulation from each end,
red) are connected
on the speakers
on the amplifier.
of approximately 15-20
during the running
as a flower, coffee or
and amplifier
service center near you
to
hours
in