EuroLite USB DMX512 PRO Bedienungsanleitung Seite 12

Getting started
Install drivers
Prior to the first use under Windows,
to install the driver software to allow your DMX software to
communicate with the interface.
eurolite.de -+ download
vary between operating systems. This manual will cover the
Windows 7 installation
example
Note: For latest drivers an OS support, please visit the FTDI
website: ftdichip.com/Drivers/D2XX.htm
documentation, please
Documents/lnstallGuides.htm
12 English
Mac or Linux you need
The driver is available
section of the product.
process on the next page, by way of
1
go to: ftdichip.com/Support/
Connect to the DMX512 network and the computer
Connect the XLR jack to the DMX input of the first DMX-
controlled device in the chain and the USB jack to a free USB
port on your computer. The interface
from:
and disconnected
Methods
without a reboot (hot plugging). Multiple units can be used at
the same
Start your lighting control software and configure
with the interface. Create your show. DMX Data is now sent
to the interface via USB where it is internally distributed to the
XLR output for DMX output to the DMX network. The status
indicator starts flashing
that no data from the computer is present.
For
from the computer
time
USB
green. A constant
can be connected to
during operation and
DMX+
it for use
red light shows