ROWENTA IN5011 Bedienungsanleitung Seite 12

EN
Maintaining your CLEAN IT
Using the auto-clean attachment
Rinses the suction 1
hose after use to
prevent unpleasant
odours and main-
tain your appliance.
Clic
Attach the auto-clean attach-
ment to the multi-purpose
suction hose cuff.
1 2
30s
Remove the clean water tank cap and Press the start button and let the appliance
put the auto-clean attachment into run for 30 seconds to clean the suction pipe.
20
the bottom of the tank.
2 3
Empty the dirty water tank if it is full. Make sure that the clean water tank
is filled up to the mark:
3
Do not use chemicals or abrasive products to
maintain your appliance.
Storing your CLEAN IT
1 2
Wrap the multi-purpose suction Clip the hose cuff into its
hose around the appliance. holder.
Our tips for effectively cleaning stains:
The newer the stain, the more effective the cleaning will be
- Do not put warm water into the clean water tank: The stain could set into the fabric
- After spraying the water/cleaning solution onto the stain, leave to act for a few minutes before
vacuuming
- To prevent rings or colour changes when drying, it is recommended to treat the entire area
around the stain rather than just the stain itself.
- Before cleaning, remove excess dirt with a cloth.
Place the device in a dry place.
EN
3 4
Wind the power cord around Store acces-
its holder. sories in the
storage bag*.
21
* Depending on models