Flush-Fitting; Post-Installation Checklist - Panasonic KY-T937VL Bedienungs- Und Installationsanleitung

Flush-fi tting
KY-T937VL can be fi tted fl ush when installing.
Installing the appliance as fl ush-fi tting
■ Only suitable for installation on heat and water resistant worktops such as
marble, natural stone, solid wood (if cut out edges are sealed).
■ Mount onto other types of worktops only with the recommendation of the worktop
manufacturer.
■ Remove the cushion from the underside of the appliance before fl ush fi tting.
■ The internal width of the base unit must be at least as wide as the internal
cut-out width for the hob. This is to ensure that the casing can be easily removed
for maintenance.
■ Before sealing in, test that the appliance works. Grout the perimeter using a heat
resistant silicone. Smooth the seal with a suitable fi nishing product.
Follow the silicone instructions and do not turn on the appliance until the silicone
is completely dry.
490
524
29
CAUTION
■ Please observe the diagrams for the cut-out dimensions in granite
and marble worktops.
■ Using unsuitable silicone may cause permanent colour changes to
marble worktops.
Uninstalling the appliance as fl ush-fi tting
■ Disconnect the appliance from the mains.
■ Remove the silicone seal from the perimeter with a suitable tool.
■ Push the appliance upwards from below to remove it.
CAUTION
Do not try to remove the appliance by prying it out from above.
54
EN-
(measurement: mm)
R3
R3
17
870
5.5
904

Post-installation Checklist

Upon completing installation, check and mark off the following items.
Checklist
Appearance ■ Ensure that the appliance is not tilted.
■ Is the top plate clean?
Electrical ■ Is the power supply a single-phase (220-240 V ~), or a
work three-phase (380-415 V 3N~)?
■ Has the earth been installed?
■ Has the earth leakage circuit breaker been installed?
Electrical
1. Touch to turn on the main power.
testing
■ Does the main power light illuminate?
2. Touch the following areas to check function of
each cooking zone:
■ Left front
■ Left middle
■ Left rear
■ Middle left
0 : 02
■ Middle right
■ Right front
■ Right middle
■ Right rear
- - -
■ Make sure to turn off each cooking zone and the main power switch after
performing electrical testing.
■ Hand the Operating / Installation Instructions to the customer.
I hereby certify that installation has been completed.
Checked
- - -
5
Does - - - fl ash?
Signature of installer
55
EN-