Kathrein BAS 65 Bedienungsanleitung Seite 20

• When installing the antenna mast, ensure that it is standing upright. Otherwise, there may be problems with the
alignment of the antenna and the satellites.
Tip: When attaching the installation support to the
mast, observe the azimuth setting required by the
antenna (see azimuth/elevation table at the end
of these instructions for use) so that the antenna
later only needs to be minimally horizontally
realigned.
Then attach the installation support (as on the right in the
picture) to the mast using the two supplied u-bolts.
Ensure that the "THIS SIDE UP" inscription on the
installation support is pointing upwards.
5.4.2 Setting the elevation for wall installation
The antenna elevation should be set before installation (chart and screws are more highly visible/accessible).
Perform setting of the antenna as follows, using the printed elevation table found at the end of these instructions
for use.
1. Loosen the two screws on the support using the enclosed
hexagon wrench (see picture on right).
2. Now set the elevation value appropriate for you
(see table at the end of these instructions for use) on the
antenna. For this, ensure that the desired value on the
chart is at the same level as the notch on the support
(see detail on right).
3. Hand-tighten the two screws again by gripping the wrench
at the short end.
4. Grip the wrench at the long end and tighten the screws by
approx. 1/4 to 1/2 turns.
The screw-tightening torque now corresponds to approx.
6 to 7 Nm.
5.4.3 Attaching the antenna to the installation support taking into account the required polarisation
value for mast installation
1. Take the antenna with the preset elevation and insert the
central bolt on the antenna support in the opening (keyhole)
provided for this in the centre of the installation support. Press
the antenna downwards until the central bolt is in the narrowed
area and the antenna can no longer fall out (see picture on
right).
Continued on the next page
→
"THIS SIDE UP" inscription
← Satellite