Assembly Instructions - Fluid Tunturi R90W Bedienungsanleitung

Assembly Instructions

..........................................................................................................................................................
STEP 1
REQUIRED
Side Rail Left / Right [2]
Rear Brace [4]
Bungee Hook Mount [5]
Transport Wheel Assembly [6]
4x M6x15mm Bolts [12]
WARNING
Rotate Rear Brace to correct
orientation before assembly
onto Side Rails
NOTE
Transport Wheels must be
mounted on the outside of
Side Rails as shown below.
Do not over tighten the
Transport Wheel Axle as it
may inhibit Transport Wheel
rotation.
Transport Wheel Assembly
M8 Washer
M8 Washer
M8 Nylock Nut
Installing the Rear Brace and Transport Wheel Assembly
to the Side Rails
A) Start with the Rear Brace and on the underside you will find a Pre-
installed bolt. From the Hardware Kit, take the Bungee Hook Mount
and install it onto the Rear Brace as shown. Note the orientation
of the Brace and Hook must be correct in order to hold the end of
the Bungee Shock Cord as depicted by the arrow in the illustration,
which points toward the front of Rower.
Pre-installed Bolt
Bungee Hook Mount
B) Next, connect the Side Rail Left and Side Rail Right[2] using 4x
M6x15mm Bolts[12] and Rear Brace[4]. DO NOT TIGHTEN.
Tip: Bumpstops facing inside of rail for correct assembly orientation.
C) Once the Rear Brace and Side Rails are assembled, mount the
Transport Wheel Assembly[6] onto the Left/Right Side Rails[2].
Note: One Washer on outside and one Washer on the inside of the
side rail.
M8 x 60mm Bolt
Transport Wheel
Side Rail Right
Bumpstop
Side Rail Left
M6x15mm Bolts
7
Towards Front of Rower
Rear Brace (Underside)
Rear Brace