Fluid TUNTURI R90W Bedienungsanleitung Seite 11

Assembly Instructions
..........................................................................................................................................................
STEP 4
Tighten Frame
Bolts securely
once Rower is
standing.
Attach Bungee Code And Completing the Rower Assembly
Once the Bungee Cord is attached to the Rear Brace,
tighten the Bolts holding the Footboard, the Main Frame
to Side Rail Bolts as they are easier to access from the
vertical position.
Lower the Rower back to the Horizontal position and test
for proper bungee recoil.
Check Seat Rollers/Runners for dirt or debris before
sitting on the Rower Seat. Small objects captured
between the Seat Rollers and Runners can damage the
Wheels or running surface. Check Runners for debris prior
to each use and clean regularly.
Note: The Rower Frame Bolts require periodic checking
for tightness. Do this at the end of the first month of use
and again after every 12 months.
Choose a suitable location when standing the product for
storage.
The Rower Frame can be polished with any high grade
furniture polish to further highlight the rich luster of the
wood finish.
Install supplied 2x D Cell Battery and check Monitor
function. Details regarding can be found in the Monitor
section of this manual.
Choose a flat, level surface on which to use your Rower,
to avoid rocking and potential premature wear.
Pull Bungee Cord and Hook Bungee End onto the
Bungee Hook Mount[5] as shown.
9
Do not cut Bungee tie
wrap before Bungee cord
is attached to rear of
Rower as shown here.