Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8
ENGLISH
3. LIFT-OFF PROCEDURE
- Put the helicopter on a smooth surface. Uneven floor surface will affect its lifting off.
- Slowly increase the throttle.
- DO NOT look at the transmitter but focus on the helicopter.
-As soon as the helicopter leaves ground, reduce the throttle slightly. (in the worst case, helicopter will go back to the floor,
but that is better than crashing against the ceiling)
- VERY gently add the throttle if the helicopter goes down.
- VERY gently reduce the throttle if the helicopter goes up.
- For turning, give short and small inputs to the right control stick. (most beginners will easily over control the helicopter)
- For moving forward, direct the helicopter to more open space before pushing the right stick.
- Press the "LIGHT" button to switch on the light at the nose of helicopter.
9. Replacement
GOOD
PILOT
FLIES
HELICOPTER
AND
LOW!
Main
rotor
blade
IMPORTANT!
After replacementof the'mainrotorblades.The 6 screws
on the main rotor blades may be loosening after several
flights with crashes. Tighten them one by one using the
screwdriver accordingly.
10. Trouble
Sympto
Propeller can't move.
The power indicator on transmitter blinking.
Suddenly stop and drop down when flying.
Helicopter
does not react.
Loss of control.
1 1, Specification
Channel
Frequency
Modulation
Control range
Battery low detection
Power saving mode
Battery requirement
for Helicopter:
Power Supply
Rating
. DC 7,4V , 22 W
Batteries
. 1 x 7,4 V LiPo Rechargeable Battery Pack (included)
Capacity
300 mAh
(after Trimming
procedure):
THE
CLOSE-BY
Shooting
- ONIOFF
Switch
is "OFF".
- Weak Battery.
- Weak power of transmitter.
- Weak power.
- Channel
selection
on transmitter
- Another radio control device using the same frequency
and channel is operated near your helicopter.
- Out of the control range of distance.
ransmitter
27.145
MHz
AM
Up to 25 meters
Power
indicator
blinks
once each second
Power
indicator
off
Gause
is not correct.
Power adaptor (input power)
Charging rate
Gryo
Gyro control
Battery pack
Battery
requirement
Power supply .
Rating
Batteries
Stabiliser
1
4
5
2
3
6
- Set switch
to "ON".
- Re-charge the battery pack.
- Change new batteries in transmitter.
- Re-charge the battery pack.
- Reset
the correct
channel.
- Move to another place where without radio
frequency interference
from another device.
- Ensure the antenna is fully extended. The control
range for helicopter is up to 25 meters.
BåtteryCharger
100-240 V, 50 Hz 160 Hz
12 V, IA
Héiicopte
Built-in
Heading-lock
7.4 V, 300 mAh LiPo battery (included)
for Transmitter:
: DC6V,
1,2W
• 4 x
V "AA"/LR6/AM3
linkage
(not included)
Werbung
