4
ENGLISH
4. Battery
Installation
4.1
Batteries
- The helicopter is powered by 1 x 7,4 V rechargeable
- The transmitter is powered by 4 x 1,5 V "AA" size batteries.
4.2 Battery Installation
Make sure the power switch is on "OFF" position
1 . Pres
s
down thebuttonO onbattery c over, a ndthen follow thearrow@ direction t o push outthebattery c over. ( P1)
2. Insert 4 AA batteries with correct polarity, as shown inside battery compartment
3. Close the battery compartment
cover. (P 3)
4.3 Battery Installation
Make sure the power switch is on "OFF" position.
1. Use screwdriver to loosen screw in counter-clockwise. (P 4)
2. Connect the plug of the battery pack to the helicopter. (P 5)
3. Insert the battery vertically into the battery compartment. (P 6)
4. Close the battery cover using a screwdriver.
4.4 Battery Charging:
I. Connect the plug of the power adaptor to the battery charger. The power indicator will light up. (P 7) Connect the plug of the battery pack to the charger. The charging
process will begin automatically
and the green charging indicator will flash (P 8).
2 After charging is completed, the charging indicator will turn off automatically. Disconnect the battery pack from the charger(P 9)
3. The helicopter can have about 5-6 minutes of play time after 20-45 minutes charging.
2.
Power
indicator
The power indicator and the battery charging indicator have the following
MODE,
Charging
Error
Charging completed
No battery connected
Note: If the charger enters "Error" mode, remove the battery immediately and unplug the battery charger from AC source.
& Charging
battery pack.
: Transmitter
: Helicopter
Battery charging
indicator
indication:
Power
indicator
On
Flash
On
On
(P 2)
—o—
Batte
charging indicator
Flash
o