Setting Up Programmed Operations - Panasonic CZ-ESWC2 Bedienungsanleitung

Setting Up Programmed Operations

Correctly set the present time and today's day of the week.
Unless both are correctly set, the programs will not run as expected.
• Up to 6 programmed operations can be set per day for each group and day
of the week.
• A combination of the below operations can be set for each timer program.
– Air conditioner starting/stopping
– Remote controller operation enable/disable *1
• To change the settings of an existing program, use the same below
procedure used to set up a new program.
*1 The remote controller operation enable/disable setting is disabled
depending on installation conditions. If so,
the button is pressed.
For more information, contact your dealer.
STEP 1 Press the PROGRAM button to select a group.
• When the PROGRAM button is pressed, the group
No. and today's day of the week start blinking and the
present time indication changes to a blinking "PG-1".
• Press the GROUP button to select a group for
programmed operation and then press the SET
button.
NOTE
• Group selection is disabled depending on installation
conditions. If so, proceed to the next step.
• The number of selectable groups is set during
installation.
STEP 2 Press the DAY button and select a day of the week for
programmed operation.
• When the SET button is pressed, the program
schedule marker (
lighting and, at the same time, the time set in program
starts blinking. Also, the present time indication
changes to a blinking "PG-2".
NOTE
• The currently selected day of the week blinks slowly at
this time.
EN-8
appears on the display when
) changes from blinking to
Example settings