MSW Motor Technics MSW-ISU-TECH Bedienungsanleitung Seite 19

3.4.2. Parallel Cutting
The stop can be fixed for parallel cutting. Turn the screw 1 (Figure 5) to clamp the stop in the slot. Guide
the workpiece past the cutting wire along the stop.
3.4.3. Small sections of long profiles
Small sections of long profiles can best be cut by laying a waste piece 1 (Figure 6) between the stop and
the work piece and then cutting against the stop. The cutting wire then cuts into the waste piece and the
edges remain clean.
EN
Figure 5
Figure 6