Changing Camera Settings; Motion Detection Sensitivity - Panasonic VL-SWD501EX Bedienungsanleitung

6. Using a camera

6.6 Changing camera settings

You can change the settings to match how the camera is used.
How to change the settings (using the main monitor)
1. From the top menu of the main monitor, touch
2. Select the number (1 - 4) of the camera to be configured.
3. Touch the item name, function name, and setting contents.
R Operations may have to be repeated depending on the function.
4. To end the operation, press
Note:
R The setting function screen automatically quits if an incoming call is received or if no operations are performed for
about 90 seconds.
R In the following table, < > indicates the default settings.
Item name: Sensor settings
Function name
Sensor selection
*1
Heat sensor detection
*1
Motion detection
Day and night switch
Time with no detection
Heat sensor sensitivity
Motion detection
sensitivity
26
.
Setting contents and other information
Heat sensor only, <Heat sensor + motion detection>, External sensor only, All
sensors, Off (disables all sensors)
<Night only>, Always
R Select the time period for heat sensor detection.
– When [Night only] is selected, the heat sensor operates according to the settings
of [Day and night switch] (® page 26).
Day only, <Always>
R Select the time period for motion detection.
– When [Day only] is selected, motion detection operates according to the settings
of [Day and night switch] (® page 26).
<Auto>, Timer
R Select whether to automatically set the day and night switch settings or set them
manually to a preferred time.
– This setting is active when the [Heat sensor detection] or [Motion detection]
settings are set to [Night only] or [Day only].
Auto: the camera automatically switches between night and day modes depending on
the brightness of the surrounding area.
Timer: allows you to configure the time for the night.
(After selecting [Timer], set the time with [+] and [–], and then touch [OK].)
<10 seconds>, 30 seconds, 60 seconds
R Select the time after an image is detected by a sensor or a monitored image is
displayed until the sensor can make detections again.
– Select a long time period if you do not want the sensor to make frequent
detections.
High sensitivity, <Normal>, Low sensitivity, Very low sensitivity, Do not detect
R If it is difficult for the sensor to make detections, select [High sensitivity]. If detections
are being too frequently made, select [Low sensitivity] or [Very low sensitivity].
High sensitivity, <Normal>, Low sensitivity, Very low sensitivity
R If you want to detect small changes in motion, select [High sensitivity]. If you do not
want to detect small changes in motion, select [Low sensitivity] or [Very low
sensitivity].
® ® [Connected devices] ® [Camera].