Werbung
Verfügbare Sprachen
Verfügbare Sprachen
of the single sideband.
SSB search function will end up 5 seconds later.
-When "•SSB" flashing, short press [MODE), the Ower sideband "LSB"
flashing or not flashing, orthe "•SSB" flashing, short press (BAND], it can
switch
to SW
Band.
On SW state, tune off the radio, and then tune on the radio, LSB or SSB will
enter the Searching mode automatically
If you would like to exit the SSB and LSB Searching mode, short press the
[SET] 4 times, press lightly [MODE], and it can switch to "AM" flash. And
then, press lightly the [SET], and it can exit the Searching mode of LSB and
SSB.
14.4: AIR (Airband Reception) Status:
14.4.1. Press [SET]. When the bandwidth (BW) flashes, short press [MODE]
to set the bandwidth
6.00KHz,
and 4.00KHz.
14.42. Press [SET] twice, SQ (SQ.OFF.OO) will flash; then, short press
IMODEI to select SQ of (SQ.ON.01-SQ.ON.09).
SQ' stops flashing.
-And also no operation within 5 seconds, default current operation. short
press (MODE) to select (SQ.OFEOO) and the SQ will be closed.
14.4.3: Press [SET] 3 times, ATT/DX,'LOCAUNORMAL display will be
flashing. -Then, short press [SET] to select ATT/DXJLOCAUNORMAL
settings.
-Short press [SET] again, ATT/DXJLOCAL/NORMAL display will stop
flashing. (DX) or (LOCAL) will exit if there is no operation within five seconds
and the work will be switched to be the current default setting.
14.5: CB (City Band Reception) Status:
14.5.1: Press [SET]. When the bandwidth (BW) number flashes, short press
IMODEI to set the bandwidth to be 3.00KHZ, 2.50KHZ, 2.00KHZ, 1.80KHZ,
1.OOKHZ, 6.00KHZ,
14.5.2: Press [SETI twice and the SQ (SQ.OFF.OO)will flash. Then short
press [MODE) to select SQ of (SQ.ON.OI -SQ.ON.09). If the SQ OFF is not
needed, please short press [SET] for the second time. When the SQ
(SQ.ON.01—SQ.ON.09) is flashing, short press MODE to select (SQ.OFF.OO)
to turn off the SQ
14.5.3: Press [SET] 3 times, ATT/DX}LOCAUNORMAL will flash, and then
short press [MODE] to select ATTIDX/LOCALJNORMAL setting.
-Short press [SET]. ATT/DX/LOCAUNORMAL stops flashing.
ATT/DX/LOCAL/NORMAL will exit if there is no operation within five seconds
and the work will be switched to be the current default setting
14.6: VHF(UHF) state:
to be 3.00KHz,
and 4.00KHZ.
2.50KHz,
2.00KHz,
Short press [SET], TOL
11
1.80KHz,
1.00KHz,
Werbung
