Werbung
Verfügbare Sprachen
Verfügbare Sprachen
current setting if there is no operation within five seconds.
When 64.00MHz is displayed, it means that FM receiving range is
64.00-108.00MHz
When 76.00MHz is displayed, it means that FM receiving range is
76.00-108.00MHz
When 87.50MHz is displayed, it means the FM rece'ving range is
87.50-108.00MHz
14.2.3. Press [SET] 3 times, ATT, OX, LOCAL or NORMAL will flash; then
press [MODE), to selectATT, DX, LOCAL or NORMAL.
-After it is selected, press the [SET] key to confirm the current selection. ATT,
DX, LOCAL or NORMAL stops flashing. Default the current setting if there is
no operation within five seconds.
14.2.4. Press [SET] 4 times, "De-emphasis: 50us or Demphasis: 75us" will
flash. Short press [MODE] to choose De-emphasis: 50us or Demphasis
75us; press SET again to confirm the current operated. De-emphasis: 50us
or Demphasis: 75us words will stop flashing. Default the current setting if
there is no operation within five seconds.
14.2.5. Press [SET] 5 times, "STEREO" or "•MONO" will flash; then, short
press MODE to select the "-STEREO" or "'MONOI' setting.
Press SET, to confirm the current operation. Default the current setting if
there is no operation within five seconds.
14.3: SW receiving state:
14.3.1: Press [SET], bandwidth "BW flashes, short press (MODE] to set the
bandwidth
to be 3.00KHZ,
6.00KHZ,
and 4.00KHZ,
14.3.2. Press [SET] twice, and "SQ.OFF.OO.ON' flashes.
Press "MODE" to select (SQ.ON.OI —SQ.ON.09)SQ level, which has 9 levels.
Then short press SET to confirm the SQ level you need. "VOL SQ" will be
flashing on the screen.
Default the current setting if there is no operation within five seconds.
-If the SQ function is not required, press the above operation to switch to
VOL SQ OFF to turn OFF the automatic
14.3.3. Press [SET] 3 times, ATT, NORMAL, OX, or LOCAL is flashing.
-Press [MODE) to select ATT, NORMAL, DX, or LOCAL setting.
After that, short press [SETI to confirm the setting. ATT, NORMAL, DX, or
LOCAL will stop flashing. It may exit (DX) or (LOCAL) to switch operations
and default the current setting if there is no operation within five seconds.
14.3.4. Press [SET] 4 times.
"'AM' display flashes and SW works on the normal short-wave receiving
mode.
-Short press [MODE), the "•SSB" flash to enter the upper side search mode
at this
time.
at this
time.
at this
time.
2.50KHZ,
2.00KHZ,
1.80KHZ,
noise function.
10
I.OOKHZ,
Werbung
