Operating The Appliance; Grilling With Water And Lava Stones; Setting The Grill; Preheating The Grill - Siemens ET375CUA1E Gebrauchsanleitung

Operating the appliance

en
1Operating the appliance
In this section, you can find out how to set your
p l i a n c e O p e r a t i n g t h e a p
appliance. In the table, you can find the settings for
various dishes.

Grilling with water and lava stones

Fill the grill container with water before each use.
Note:
Otherwise the appliance will overheat.
The amount of water depends on whether you want to
use lava stones. The lava stones store the heat from the
grill element, leading to intense radiation of heat and
even heat distribution.
Filling with water and lava stones
Remove the wire rack and fold up the grill elements.
1.
Remove the lava stone container from the appliance.
Ensure the drain valve is closed.
2.
Fill the grill's container with water.
3.
Grilling with lava stones: 0.7 litres (bottom mark)
Grilling without lava stones: 2.5 litres (top mark)
To grill with lava stones: Remove the lava stones
4.
from the packaging and place them in the lava stone
container. Insert the lava stone container in the
appliance.
Fold down the grill heating element, replace the wire
5.
rack.
The grill is ready to use.
16

Setting the grill

The dial allows you to adjust the grill's heat setting. The
dial has no increments – the heat setting is infinitely
variable. The indicator light will light up when the grill
has been switched on.
Turn the dial to 0 to switch off the appliance.
The grill regulates the temperature by switching
Note:
the grill element on and off.The grill element may also
switch on and off at the highest setting.

Preheating the grill

Do not place the food to be grilled under the grill until
the preheating time has elapsed. Use the information
provided in the grill table to guide you. Always preheat
the grill at setting 9.
Preheating takes between 8 and 12 minutes.
Preheat the grill without food under it for no
Note:
longer than 8-12 minutes.Leaving the grill to heat up for
prolonged periods of time may cause the appliance to
shut down (overheating protection). Switch off the
appliance and allow it to cool down before switching it
back on again.

Overheating protection

The overheating protection switches the grill heating off
when the grill overheats. When the grill has cooled
down sufficiently, grill heating switches on again
automatically.