Use With Dect Cordless Telephones; R Eplacing Battery Pack (Gn Accessory); Adding Extra Battery Charging Facility; Replacing Battery Pack - Jabra GN9330e USB Anleitung

5. Use with DECT cordless telephones

GN9350e GN9330e GN9330e USB
Your headset can also be used with DECT cordless telephones (Digital Enhanced Cordless
Telecommunication), which are GAP-compatible (Generic Access Profile). You must first pair
the headset to the base unit of the cordless telephone.
Important: Your headset's authentication code is 0000, which is the same code as for most DECT
cordless telephones. Your headset will only work with cordless telephones with the 0000 code.
To pair your headset to your DECT cordless telephone:
1. Press and hold down the headset's talk button and mute button (at tip of volume control)
for 5 seconds.
–> The headset's link indicator will flash rapidly.
2. Activate the cordless telephone's GAP mode. Consult your cordless telephone's manual
GAP compatibility/pairing instructions.
–> The headset's link indicator will light for 2 seconds to indicate successful pairing.
Your headset is now ready to use with your cordless telephone. Consult your cordless
telephone's user manual for using your headset with your cordless telephone.
6. Replacing the battery pack (GN accessory)
GN9350e GN9330e GN9330e USB
6.1 Adding extra battery charging facility
An extra battery charging facility is available as an accessory. This
can be attached to your base to allow you to charge an extra battery.
To add the extra battery charging facility cover:
1. Remove the blind cover from the base by sliding it upward until
removed.
2. Slide the extra battery charger into the base charge tower until it clicks in place.
The extra battery can be charged in its receptor on the back of the charge tower. An indicator
above the receptor will light when the battery is placed correctly and is charging. The indica-
tor will turn off when battery is fully charged.
14
Important: During everyday use, the base's leftmost indicator will flash when there is less than
30 minutes of talk time left.
GN9350e GN9330e GN9330e USB
6.2 Replacing the battery pack
The headset's battery pack can be changed when required.
To replace the battery pack on a wearing style:
1. Unclip the wearing style from the battery pack.
2. Slide the battery pack off the headset.
3. Slide the new battery pack (from the extra battery charging facility) onto the headset.
The headset's link indicator will light for 2 seconds to confirm successful replacement of
the battery pack.
4. Replace the wearing style.
5. Recharge the empty battery by sliding it into the extra battery charging facility.

7. Audio and visual indicators

The headset and base have audio and visual indicators that represent various functions
associated with setting up and using the product.
GN9350e GN9330e GN9330e USB
7.1 Headset's audio indicator
Headset action Audio indication
Low battery 5 rapid beeps + 20 second pause
Volume up/down 1 quick beep in increasing/decreasing intensity
Volume max/min reached 1 rapid shrill/low beep
Incoming call (with RHL functionality) Rapid multi-tone + 2 second pause (repeats)
Incoming call (with VoIP call) Depends on VoIP application
Conference call request 4-pitch tone
Conference call accept 1 beep
Telephone line (open/close) 1 beep
Headset out of range 3-pitch tone
Mute activation/deactivation 1 beep
Mute activated 2-pitch tone + 10 second pause (repeats)
15