Air Regulator - Vector Welding Wig 2000 Bedienungsanleitung

DC SERIESEQUIPMENT
Operation
3.5 Setup for cutting (CT 520PD)
In order for the unit to function correctly,
given below for correct installation
1. Read the safety rules given in this manual carefully.
2. Check on receiving the unit that there are no defective
transportation.
3. Set your unit up in an area which is adequately
are not obstructed.
4. Connect the power supply cable to a socket
so that the unit can be switched off quickly
5. Your machine has a 16 amp plug fitted,
connected to the earth pin socket of fitted plug.
6. Make sure that the mains supply switch and any fuses have a value which ± 15% the
maximum current absorbed by the unit. All fuses should be the slow-blow
7. Any extensions of power supply cable should have the same cross-section
supply cable. The extension leads, however,
necessary. It is important to note that any extension
possibly affect the cutting performance
resistance of the cable will reduce voltage
cable. The supplied length of main cables
8. Fasten the earth clamp to the piece to be cut, If the surface
rusty or covered with insulating material, clean the surface so that satisfactory
between the piece and the earth clamp can be obtained.
9. Make sure that the torch has been assembled
cutting tip is suitable for the cutting current.
10. Connect air to regulator and adjust regulator
II . Switch the unit on using the main switch
12. Contact the copper tip of the torch to the work piece,
the arc-starting and raise the cutting torch about
the cutting operation.
13. Once cutting is over, release the torch button
time 45 to 75 seconds (required for torch cooling)
until this cooling period has been completed.
damage.
CAUTION
Do not point the torch jet at foreign bodies.
CAUTION
Avoid unnecessary lighting of the
consumption of the electrode and nozzle.
it must be installed properly. Follow the procedure
parts or parts damaged
ventilated and make sure that the air vents
located as near as possible to the work area,
in case of emergency.
before use check that the greenlyellow
type.
as the power
should only be used when absolutely
of mains cables or torch cables will
of this cutting equipment, due to the fact that the
input, which is determined by the length
and torch cables is recommended.
of the piece to be cut is painted,
with the correct components and that the
to deliver 5-6 bar 901tr/min
located on the back side.
press the button of the forch
I mm above the work piece, and perform
to put out the arc. Aperiod of post-flow
will follow. Do not disconnect
Failure to do this will result in torch head
pilot arc to prevent excessive
Air compressor
during
earth is
Earth Clamp
of the
contact

Air regulator

until
1 . Firmly tight and seal the copper air hole at IN and OUT terminal
tube
2. Tight and seal the meter with meter face rubber
air
3. Fix the connecting
4.Get down the plastic
5.Turn on the air valve, turn up the pressure adjusting knob, turn the pressure volume (meter
inside shows
decreasing pressure.)
6 Scale of the meter is as follow. The volume in the picture is 6 kg
7. If the water in thegas filtering bottle is too much, please turn on the water valve to let the
water go out.
OCTIG SERIESEQUIPMENT
CT520PD
ooo
installation and operation
tube.
shelf with screw as the regulator position.
screw and fix the regulator on the shelf.
kg), and then put down the knob.(+ means
4
Operation
power supply
Plasma torch
by high pressure rubber
increasing pressure, - means