Werbung
Verfügbare Sprachen
Verfügbare Sprachen
A robbe
EED
The controller features a range of protective
tions, and in everyday operations
the unit may shut
the motor
down
for a variety
of reasons.
You should
be aware
of the possible
causes:
• The speed controller will shut off the motor (brake
active) if it overheats
(e.g. if the motors are too po
werful, are run constantly
at part-load,
or if cooling
is inadequate),
if battery voltage falls below a cer
tain level, or if the transmitter
signal fails or suffers
interference.
The
controller
can
be
re-activated
by moving
it to the STOP range
and then forward
again,
but only after you have
removed
of the
shut-off.
•
f the controller
is in the „OFF" state as described
above,
the
LED flashes
at two-second
intervals.
SAFETY
INSTRUCTIONS
• Observe
the
technical
data
of the
controller.
• Observe
the polarity
of all connection
cables.
• Avoid
short
circuits
at
all costs.
nstal or package
the regulator
so that it cannot
• Effective
interference
suppression
measures
suppression
capacitors
• Ensure adequate
air circulation.
• Never reach
into the turning
circle of the propel er during
Dealing with model aircraft and vehicles requires technical
awareness.
Incorrect assembly, incorrect adjustment,
injury or damage
to property. Sudden starting of connected
ting parts such as propel ers. Always stay away from these rotating parts when the power source is
connected.
All drive components
should be safely and securely mounted
is only permitted
within
the scope
of the technical
Before use, check
that the speed
controller
ver operate
the speed controller (correct speed controller) with external power supply units. Speed
controllers
should a ways be protected
from dust, moisture,
Even splash-proof
or waterproof
equipment
moisture.
High operating
temperatures
or poor cooling
temperature
range
should
be approximately
and do not cause
reverse
po arity which
would
disconnect
the device
from the motor
or battery
with sufficient
load capacity.
Avoid
strong bending
termination
of flight or driving
operation,
disconnect
battery.
This would
cause
permanent
damage.
BEC power
of the device
is sufficient
for the servos used. Speed
away
as possible
from other
remote
control
test before
operation.
We recommend
regular
visible damage.
Do not continue
operating
tion cables must not be extended.
This can lead to unwanted
and protective
devices of the device, damage
warranty also expires if changes are made to the device.
USER
NTROLLE
s
func
the cause
LED
FOR
CONTROLLERS
come
into contact
with grease,
oil or water.
on the electric
motor with, for example,
start-up
Risk of injury
understanding
and a high level of safety
improper use or the like can lead to persona
motors can lead to injuries due to rota
during a function test. Use
specification
and only for RC hobby
is compatible
with your drive motor
or power
vibration
and other
mechanical
should
not be permanently
exposed
to moisture
shou d be avoided.
The recommended
between
-50C and +500C. Ensure proper
permanently
damage
the speed
controller.
during
operation.
Use high-quality
plug systems
or tensile stress on the connecting
the battery
to prevent
deep
discharge
For the BEC version of the controller,
check
controllers
should
be installed
components.
We recommend
carrying
out a range
checking
of the controller
for function
the control er if you notice any damage.
The connec
malfunctions.
Despite existing safety
may occur which is not covered
by warranty. The
MANUAL
Important
information:
The receiver
system is powered
For commissioning,
a ways move
transmitter.
On y then connect
motor
controller,
first then turn off the transmitter.
rudders
to neutral
position
midd e position).
Please make sure to leave
does not start. For all work on to the parts of the remote
instructions
supplied
with the units. Also read the instructions
before
commissioning.
Check
the engine
mounting
TASTER
Button
Touche
Our articles
are equipped
justified
warranty
claim,
cessing.
During this time, any functional
problems,
will be rectified.
consequential
damages,
is also free. Freight collect
damage
and loss of your consignment.
To process your warranty claims, the following requirements
• Attach the proof of purchase (receipt) to your shipment.
• The units have been operated
• On y recommended
• There is no moisture damage,
damage.
• Attach relevant information
Robbe Modellsport cannot monitor compliance
conditions
and methods
Therefore, we accept
no liability for osses, damage
with incorrect use and operation.To
applications.
source.
Ne
irrespective
of the legal grounds, shall be limited directly to the invoice value of the claims arising
from the event
causing
stresses.
or
Robbe
connection
requirements
Never
The original
robbe.com,
cables.
After
on request.
of the
that the
as far
and external
y
This symbol
of at the end of their useful life, separated
of the device at your ocal municipal collection
applies
a separate
NAVY
CONTROL
by the built-in
BEC system of the controller.
the throttle
stick to the „Motor
off" position
the battery.
To switch
off always
disconnect
During the functional
with the remote
control
(stick and trimming
the throttle
stick in the lowest
control,
motor or controller,
of the battery
bolts in the fuselage
regularly
for tightness.
WARRANTY
with the egal y required
24 months
warranty.
always
contact
your dealer,
who is responsible
defects
that may occur,
as well as manufacturing
Material
defects
corrected
by us free of charge.
are excluded.
The transport
to us must be free, the return
shipments
cannot
be accepted.
We cannot
We recommend
appropriate
must be met:
in accordance
with the operating
power sources and original robbe accessories have been used.
external interference,
reverse polarity, overloading
for finding the fault or defect.
DISCLAIMER
with the assembly and operating
for installation,
operation,
use and maintenance
or costs arising from or in any way connected
the extent permitted
by law, the obligation
the damage.
CONFORMITY
Model
sport hereby
declares
that this device
and other
relevant
regulations
of the corresponding
declaration
of conformity
can be found
in the detai ed product
view of the respective
This product
can be operated
in all EU countries.
DISPOSAL
means
that small electrical
and electronic
from the household
to all countries
of the European
Union and other
collection
system.
540
R NO.
8616
and switch
on the
the connection
battery
test, move
the servos of the
lever on the transmitter
to the
position
so that the engine
follow
the
and the charger
careful
y
Shou d you wish to assert a
for the warranty
and the pro-
or other
Further claims, e.g. for
transport
to you
accept
liability for transport
insurance.
instructions.
or mechanical
instructions or the
of the model
components.
to pay damages,
complies
with the essentia
CE directives.
on the Internet
at www.
device
description
or
devices
must be disposed
refuse. Dispose
point or recycling
centre. This
European
countries
with
5
Werbung
