Before Use; Use; Programming Quantity - Wilfa Volo Capsule Mini Anleitung

EN EN
CONTROL PANEL OVERVIEW
Small cup
Off: Press small and large cup at the same time.

BEFORE USE

• Remove all stickers, protective foil and
plastic from the appliance.
• Place it on a flat stable surface.
• Before using it for the first time or after a
long time:
• Press any button to turn the machine
on. The machine is heats up and the
lights stop blinking.
• Fill the water tank up to the max mark
with cold fresh water (See filling water
tank).
• Place a large container under the
dispenser.
• Make sure there is an empty adapter in
the machine.
• Press the large cup button. Open the
handle when it is finished and empty
the container.

USE

Insert the power plug. Press any button to
switch the machine on.
For a better coffee experience, buy the
Wilfa espresso accessories on Wilfa.com.
FILLING WATER TANK
You can fill the water tank when it is placed
onto the machine. Remove the water tank lid,
fill it up to the max mark by using a jug or simi-
lar. Do not exceed the MAX-mark.
You could also remove the water tank and fill
it directly at the sink. Do not overfill. Slide the
water tank slowly back on the machine. When it
is correctly placed, firmly push it into place.
CAPSULE
There are two sorts of capsules you can use
with the adapters: Dolce gusto and Nespresso
Medium cup Large cup
Original.
1. Choose your desired coffee capsule and
place it into the correct adapter.
2. Lift the lever completely and insert the
adapter. Close the lever.
3. Place a cup under the coffee dispenser.
4. Press the preferred size button.
GROUND COFFEE
We recommend that you use about 8-10 grams
of coffee beans. Grind them to espresso size.
1. Place the ground coffee into the basket in
the adapter.
2. Use the tamper to push the coffee firmly. It
shall not exceed the max line.
3. Lift the lever completely. Insert the adap-
ter into the coffee machine. Close the
lever.
4. Place a cup under the coffee dispenser.
5. Press the preferred size button.
ENERGY SAVING
After 9 minutes of no activity, the unit goes
into energy saving-mode. Press any button to
activate the machine.

PROGRAMMING QUANTITY

SET THE COFFEE VOLUME
The volume can be adjusted from 25-250ml.
1. Lift the lever and insert the adapter with
the coffee of your choice.
2. Push and hold button until the desired
volume is reached. Release the button.
The chosen amount is stored automatically.
When you use it again, the cup size has been
memorized.
RESTORE FACTORY SETTINGS
If you want to restore the quantities to factory
settings:
1. Take out the power cord and open the
lever.
2. Press and hold the small cup and medium
cup buttons.
3. Plug in the power cord. There is one beep.
Let go of the two buttons.
4. Close the lever. It will beep two times.
5. Press and hold all buttons. There will be a
long beep. Plug out the power cord.
6. Plug it back in and press any button to
switch the machine on. A button will flash
in red.
7. Make sure there is water in the water tank,
8