Service; Storage And Transportation; Disposal; Possible Malfunctions And Troubleshooting Methods - Dnipro M Sr-210 Rx Betriebsanleitung

After turning off the tool, wait for the saw
blade to come to a complete stop before
placing the power tool down.

9. SERVICE

Unless otherwise expressly provided for
in this manual, the product must be ser-
viced only by the manufacturer (DNIPRO
M LLC), the DNIPRO-M authorised service
centre or the seller of the product.
Regularly (preferably after each use),
wipe the housing of the power tool with
a soft cloth. Ensure that the ventilation
openings are free from dirt and dust. If
heavily soiled, blow them out with com-
pressed air.
Do not use solvents such as gasoline, wa-
ter-ammonia solution, etc., as they can
damage the plastic parts of the power
tool.
Ensure that moisture does not enter the
openings on the power tool's housing.
In case of damage to the power cord,
contact the manufacturer (DNIPRO M
LLC), the DNIPRO-M service centre or the
seller of the product for replacement.
12.

POSSIBLE MALFUNCTIONS AND TROUBLESHOOTING METHODS

Description of
malfunction
Electric tool
does not turn on
Overheating of
the motor hous-
ing
EU-SR1123001-1123001
Possible causes
Damage to the power cord Contact the manufacturer (DNIPRO M
Malfunctioning power
switch
Overloading of the elec-
tric tool
Poor cooling
10. STORAGE AND
TRANSPORTATION
It is recommended to store the power
tool in a dry place that is inaccessible to
children, at a temperature ranging from
-20°C to +60°C, and at a relative humidity
not exceeding 80%.
If the power tool has been stored at a
temperature lower than the one it is in-
tended to be used at, ensure that there
is no condensation on the power tool. If
condensation forms on the power tool,
its operation or further preparation for
work is prohibited until the condensation
has completely dried. If the power tool is
used immediately after being moved from
a cold environment, it may malfunction.
For transportation of the power tool, use
the original packaging or other packag-
ing that prevents damage to the power
tool and its accessories during transpor-
tation.

11. DISPOSAL

Do not dispose of power tools with
household waste!
Power tools that have been tak-
en out of service should be stored
separately and disposed of in ac-
cordance with environmental leg-
islation.
Rectification
LLC), the DNIPRO-M service centre or
the seller of the product.
Reduce the load on the power tool.
Increase the cooling-off period for
the power tool
Clean the ventilation openings. Make
sure the ventilation openings are not
obstructed during operation
Ensure that the cooling fan rotates
when the motor is running
en
9